Calculate the partial volume of a horizontal vessel
Convert Volumetric Flow Rates
Convert Temperature Units
Calculate the volume of a cylinder
Bendel Industrial products can be fabricated
with any of the following material finish options.
These designations apply to stainless steel sheet, plate, pipe,
and bar.
Hot Rolled (HR) Rough, dull surface appearance. Most
scale removed by pickling. Applies to all steel plate 3/16" and
thicker. Specify where surface finish is a low priority.
Grit: n/a
RA Range: n/a
2B Mill Finish (2B) A smooth, bright, moderately reflective
finish suitable for "as is" specifications or as a preliminary
finish for further polishing. Available only in 1/4" or
thinner sheet material.
Grit: n/a
RA Range: n/a
No. 3 Finish A semipolished surface achieved by
finishing with the equivalent of a 120-grit abrasive. This
finish has a pronounced grit line. Typically used with
a No. 3 weld finish.
Grit: 120
RA Range: 40-50
No. 4 Finish A sanitary, general purpose, bright
finish with visible grain which prevents mirrorlike reflectivity.
Use where sanitary surfaces are required. Meets current
3A standards. Typically used with a No. 4 weld finish.
Grit: 180
RA Range: 15-30
No. 6 Finish Polished finish achieved with the
equivalent of a 240-grit abrasive. Finer grit lines and
higher reflectivity than No. 4 finish. Improved product
release, cleanability, and appearance. Typically used with
a No. 6 weld finish.
Grit: 240
RA Range: 10-15
No. 7 Finish Highly reflective surface obtained
with the equivalent of a 320-grit abrasive. Minimal grit
lines. Used where product-contact surfaces are critical.
Typically used with a No. 7 weld finish.
Grit: 320
RA Range: <10
Desktop Widget
Now you can use our popular tools and calculators directly on your desktop!
